Muzzy Digi Tune PRO for Commander 1000

Taking air/fuel tuning to the next level, the Muzzy Digi-Tune PRO uses the latest technology to provide one of the easiest and most accurate methods of tuning the Can-Am Commander.

The Muzzy Digi-Tune PRO comes pre-programmed and optimized for the Commander 1000. There is no mapping or re-mapping necessary. Adjustments for elevation and/or modifications can be done "on-the-fly" using three buttons on the faceplate.

What sets the new PRO version apart from the standard Digitune is the ability to remove fuel from the stock curve. Additionally, the Digi-Tune PRO includes the ability to run in full Closed-Loop mode by connecting the 0-5 volt input lead to the corresponding output on an air/fuel meter such as the Wego III*. The Digi-Tune PRO will use the input voltage to keep the air/fuel mixture within a pre-configured range. Closed-Loop mode eliminates the need to make manual adjustments for elevation or weather change.

WHY IT'S BETTER: 
The Digi-Tune is a load based fuel adder which works with the factory ECU. The Digi-Tune's simple push button interface and powerful load based technology renders complex table-based throttle position and RPM re-mapping systems a thing of the past.

LOAD BASED TUNING: 
The Digi-Tune ushers in the latest in tuning science – gone is the old throttle position and RPM (Alpha-N) based tuning, replaced by a powerful and highly effective LOAD BASED tuning methodology. Load based tuning is superior to old school systems because different CVT ratios place different loads on the engine. RPM and throttle position based systems cannot tell the difference from one ratio to another. The Digi-Tune knows the difference and adds the proper amount of fuel for every gear ratio, in every situation.

*Not compatible with all air/fuel meters. Air/fuel meter must have 0-5 volt output. Please specify Air/Fuel meter being used at time of purchase. The Digi-tune PRO may require air/fuel meter specific programming prior to shipping.